Have the holes drilled before opening the ptube

Product worked very well in masonry.Printing on the tube is VERY small

Worked great. Have never used this product before and was worried. I had a 5" lag failure that I had to drill out and this held the new lag and I was able to put the anchors recommended torque on the lag. Very pleased.

Sets Quick

I purchased this to mount 3/8" rebar in a 1/2" hole drilled about 6" deep in a concrete slab so I could extend the slab. Injected about 3" of stuff from back of hole and inserted the rebars, had to tap in with a hammer, worked great. Did several holes, had 20 to do, one at a time inserting the rebar. Then figured that I could speed up the process by applying the adhesive to several holes and then pound the rebars in. Did 5 holes and found the first holes with adhesive had hardened to the point that I could not insert/pound the rebars in. Only the last 2 holes allowed the rebar to enter the full depth. Lesson learned. One tube did all 20 holes which was a surprise. Make sure you have a strong caulk gun and a strong hand if you are using the full-length mixing tube. It sets fairly quick so don't let it sit in the mixing tube. This is a great product and I highly recomment it.

Sets up far too fast.

Went to use it, put on the mixing tube and ran it out until it turned a uniform gray as the instructions tell you to do. Then I walked to the job site across the room. Couldn’t squirt it out of the tube. It had hardened and clogged the tube.

dry before quarter used

Use if you have holes ready and once you start don't stop and parts ready. This product the tip will start heating up and it will harden if you have to reset stud you may not have time extremely fast acting. I've used Hilti epoxy and you can drill hole and as long in tube ok not this product.

FAST FAST FAST SETTING, EXTREME CAUTION!!!

This stuff sets up way too fast. It was a 76 degree morning when I squirted this into three holes and in less than 30 seconds the studs I needed to insert would not go into the holes because it had begun to solidify!

Easy to use to set bolts in concrete.

Product performed as listed.

Flashes be ready

It says 5 minute working time…ain’t no way. This stuff flash sets in about 30 seconds after you fill the hole. You better have your stuff together otherwise you’ll end up in a terrible mess.

Quick setting

Great product. Easy to use, fast setting with minimal cleanup.

Best anchoring adhesive!

This is the best anchoring adhesive you’ll find. Expensive but It’s the best. Once you open the container, you have to work fast. The job must be 100% prepped and ready to go. It sets up in about five minutes and the whole tube will completely hard within a 10 minutes. Be prepared and work fast. Whatever you’re installing will be down forever.

Good

Good stuff. Gets hard quick when it’s hot outside!

I purchased it to glue metal and it didn't work. It was expensive and I could not use it. I purchased another smaller tube of a different brand, and that one did work. It was disappointing considering it was not cheap.

Absolutely worthless. Did not even set at all.

This is one of the worst products I've ever bought at Home Depot. Actually worse than worthless because of the exorbitant price, and when you use it and it doesn't set at all, then you've ruined your surface and made it impossible to try again with another product (you've left a soft gooey residue that will prevent anything else from bonding).

This product is very strong, but you better hurry because it sets up in 5 minutes. I think it’s great.

Product is good but it dries to quick on the tip

I was re-anchoring a gate to my house and needed something effective this worked extremely well. Very short working time but I’m also confident that it will outlast my house.

Check Sikas website for information first

Have everything you need handy and ready and a helper if it's a lot of things to be anchoring on hot days it sets up faster, we used it in 90• and had less than a minute working time have to keep it moving through the tube or it's toast

Solid bond to concrete. Begins to gel rapidly.

This stuff is awesome. Was anchoring an iron handrail into holes drilled into paver blocks

Works fast

Works fast