I purchased the 12 ton big red shop press. I never got to put it together. I received it in a broken and damaged box missing the jack, handle and hardware. I sent it back and got a refund. I waited a week or so and thought I would try purchasing it again thinking I would get a nice package with all the parts. I was wrong. I received a package in worse condition than the first time. I don't know if it all was there as I refused it. Some parts were loose out of the package. It looked to me to be the same product I sent back earlier. It looked as if they put the missing parts back in the same box and used a whole roll of tape on it and sent it back to me. I did not reorder again

All sorts of missing hardware, build quality is okay. It works fine for what it is.

I never received 12 ton press.ups said I refused shipment so they sent it back to sender but ups never even showed up at my home.

Works fine

Little rough from shipping, just needed few bolts, nuts, & washers

No replacement parts

Needed a replacement part for it. I lost a pin was more than happy to pay for it. They wanted a copy of the receipt which I no longer have. So they just quit responding to emails and got no where with phone calls

Yes

Good product

12 ton hydraulic Press

bought the press on sale, needed it for some motorcycle repair. Worked great for the money, small enough to fit under shelving.

worth the money

Press was easy to assemble, and works very well for small tasks. My only complaint is that the ram floats around too much for precise bearing, or gear onto shaft assemby.

shop press

I bought this press to replace U-joints on farm and construction equipment. I works great. I am sure it has other uses which I will find. It is small enough to move around easily; however, I will probably install casters on the base to make it very portable within my shop. I would recommend this product to anyone needing a small press for U-joint work or similar applications.

Good press for home garage.

used this press for doing some wheel bearings on my car. Press costs less than the shop wanted just to use theirs. Works well, have also used it to bend some brakets and other uses. I would definatly recomend this press for a home mechanic.

12 ton hydralic press

the press was easy to put together. it is also, very easy to use. press comes with necessary hardware to be properly used (blocks).

Good home shop press

Setup and function of this press are slow. Design is so-so, but quality is great. For a homeowner that needs a press this size from time to time, this is an excellent buy.

Nice little press

This is a nice little press that packs a lot of punch. Easy to assemble/disassemble. I had to re-drill out the holes that the adjustable pins run through, but this wasn't a big deal. It's a good value for a home/garage mechanic. Has enough power for most automotive press needs. Comes with a set of press plates. Press punches would have been nice.