Door itself has been great. The instructions were pretty confusing though; multiple manuals were included for different door types and you had to wade through them for the specific parts of the install relevant to you. 4 stars because of that.

You'd better be good with framing and measurement. Seemed good but ended up removing wall tiles o...

You'd better be good with framing and measurement. Seemed good but ended up removing wall tiles on one side to allow for a fit between the swinging door and stationary door. If anything is out of plumb it's very obvious. But...it's a great door that is nicely engineered as the hinges swing past 90 degrees ensuring a tight fit between the two sections of glass. No leaks! Good product. Just do all of the set-up and measure a whole bunch of times!

Dreanline makes a quality door, received it in perfect condition strapped to pallet. Installation...

Dreanline makes a quality door, received it in perfect condition strapped to pallet. Installation went well after reading directions several time before beginning. Finished product looks beautiful and is water tight. Manufacturer suggests installation by professional but with basic tool skills and an extra hand, isn't that bad. Door however must be mounted into a stud, preferred double stud wall. Would recommend to anyone.

I purchased this door through another vendor. Yes, It can be installed by a DIY, however the most...

I purchased this door through another vendor. Yes, It can be installed by a DIY, however the most critical part of the installation are measure, measure, measure, and ensure your threshold is 100 percent level, not close it must be level. If you take in this task on, without a doubt by a set of Glass Suction Cups, I think 17.00 for a pair, worth ever penny to move the door around. You will need to dry set the door a couple of times. Under no circumstances do not set the glass on a tile floor without the protectors. A quality drill and a good diamond tile bit you should be fine. I did not drill into the threshold I used epoxy to set the bottom track of the fixed panel. Last, a helper is needed.